Rockwell Automation 22-COMM-D DeviceNet Adapter User Manual
Page 101
Troubleshooting
8-7
Events
Many events in the Event queue occur under normal operation. If you
encounter unexpected communications problems, the events may help
you or Allen-Bradley personnel troubleshoot the problem. The following
events may appear in the event queue:
Code Event
Description
0
No Event
Text displayed in an empty event queue entry.
1
Host Sent Reset
The DSI product issued this because it was reset.
2
EEPROM Sum Flt
Startup sequence detected corrupt EEPROM storage.
3
Reserved
4
Control Disabled
Sets the PCCC to zero.
5
Control Enabled
Sets the PCCC timeout to non-zero and sends a PCCC
control command.
6
PCCC IO Time Flt
Control by a PCCC device has timed out.
7
Normal Startup
Signifies the first event after a reset or power cycle.
8
Reserved
9
DSI Fault Msg
DSI drive faulted.
10
DN Poll Timeout
DeviceNet did not send an I/O poll message in the required
time interval.
11
DN I/O Too Long
The length of the data from the I/O scanner was too long.
12
Bad I/O Fragment
An I/O fragment from the scanner arrived out of sequence.
13
Idle I/O Message
The DeviceNet scanner was placed in the program mode.
14
Reserved
15
DSI Fault Clear
A drive fault was cleared.
16
DN COS Timeout
I/O data from a DeviceNet COS connection has not been
received in the required interval.
17
DN Poll Allocate
The adapter was allocated for a DeviceNet polled I/O connection.
18
DN COS Allocate
The adapter was allocated for a DeviceNet COS I/O connection.
19
DN Poll Closed
The DeviceNet master has closed the previous opened
polled I/O connection.
20
DN COS Closed
The DeviceNet master has closed the previously opened
COS I/O connection.
21
DN Dup MAC Flt
The DeviceNet side of the adapter has failed the duplicate
MAC test.
22
Manual Reset
The adapter was reset from the “Reset Module” parameter.
23
Host Timeout
An explicit message to a Drive host has timed out waiting for
a response.
24
Slave Timeout
An explicit message to a Slave has timed out waiting for a
response.
25
Slave Detected
A DSI slave was detected on the /slave I/O line.
26
Slave Removed
A DSI slave was removed from the /slave I/O line.
27
Language CRC Bad The language flash segment is corrupt.