Rockwell Automation 22-COMM-D DeviceNet Adapter - Manual (Page 25)

Chapter
3
Configuring the Adapter
Chapter 3 provides instructions and information for setting the
parameters in the adapter.
For a list of parameters, refer to Appendix B , Adapter Parameters . For
definitions of terms in this chapter, refer to the Glossary .
The DeviceNet adapter stores parameters and other information in its
own non-volatile memory. You must, therefore, access the adapter to
view and edit its parameters. The following tools can be used to access
the adapter parameters:
RSNetWorx for DeviceNet (version 4.01) and RSLinx (version 2.40)
were used for examples in this manual. Different versions of software
may differ in appearance and procedures.
Topic Page Topic Page
Configuration Tools 3-1 Setting the I/O Configuration 3-8
Using the PowerFlex 4-Class HIM 3-2 Selecting COS, Cyclic, or Polled I/O 3-8
Using RSNetWorx for DeviceNet 3-3 Setting a Fault Action 3-10
Setting the Node Address 3-7 Resetting the Adapter 3-11
Setting the Data Rate 3-7 Viewing the Adapter Configuration 3-12
Configuration Tools
Tool Refer To:
DriveExplorer Software
(version 3.01 or higher) DriveExplorer Getting Results Manual,
Publication 9306-5.3, or the online help
DriveTools 2000 Software
(version 1.01 or higher) DriveTools 2000 Online Help
PowerFlex 4-Class HIM (22-HIM-*) page 3-2
RSNetWorx for DeviceNet Software page 3-3
TIP: Explicit Messaging can also be used to configure an adapter and
drive. Refer to
Chapter 6 , Using Explicit Messaging .