Connecting the adapter to the drive, Connecting the adapter to the drive -5, Figure 2.5 – Rockwell Automation 22-COMM-D DeviceNet Adapter User Manual
Page 21: Item 2.)
Advertising
Installing the Adapter
2-5
1. Remove power from the drive.
2. Use static control precautions.
3. Mount the adapter on the cover, using the screw on the adapter to
secure it in place.
Important: Tighten the screw in the lower left hole to ground the
adapter (see
4. Connect the Internal Interface cable to the DSI port on the drive and
then to the mating DSI connector on the adapter.
Figure 2.5 DSI Ports and Internal Interface Cables
Connecting the Adapter to the Drive
#
Description
➊
DSI Connector
➋
15.24 cm (6 in.) Internal Interface cable
➌
DeviceNet cable
➊
➋
DeviceNet Adapter
PowerFlex 40 Drive
B and C Frames
(cover removed)
➌
Back of Cover
Advertising