Rockwell Automation 22-COMM-D DeviceNet Adapter - Manual (Page 41)

Configuring the Scanner 4-5
11. Click OK. If you changed any settings, a Scanner Applet asks if it is
OK to unmap the I/O. Click Yes to continue. The Edit I/O
Parameters dialog box closes and then the Scanner Module dialog
box (
Figure 4.3 ) re-appears. You will map the I/O in the next section
in this chapter.
Data from I/O messages must be mapped in the scanner. This mapping
determines where a ladder logic program can find data that is passed
over the network. You must map both the Input I/O and the Output I/O.
Mapping the Input I/O
1. In the Scanner Module dialog box, click the Input tab. (If necessary,
right-click the scanner in the configuration view ( Figure 4.2 ) to
display this dialog box.)
Figure 4.5 Input Page on the Scanner Module Dialog Box
Mapping the Drive Data in the Scanner
For: Refer to:
Mapping the Input I/O 4-5
Mapping the Output I/O 4-6