Rockwell Automation 22-COMM-D DeviceNet Adapter - Manual (Page 23)

Installing the Adapter 2-7
1. Reinstall the cover on the drive. The status indicators can be viewed
on the front of the drive after power has been applied.
2. Ensure that the adapter will have a unique address on the network
and is set at the correct data rate or to autobaud. If a new data rate or
address is needed, reset its switches (refer to
Commissioning the
Adapter in this chapter).
3. Apply power to the PowerFlex drive. The adapter receives its power
from the connected drive and network. When you apply power to the
product and network for the first time, the status indicators should be
green after an initialization. If the status indicators go red, there is a
problem. Refer to
Chapter 8 , Troubleshooting .
4. If the software settings for the data rate and node address are to be
used, a configuration tool such as DriveExplorer can be used to
adjust the respective parameters in the adapter.
Applying Power
!
ATTENTION: Risk of equipment damage, injury, or death exists.
Unpredictable operation may occur if you fail to verify that parameter
settings and switch settings are compatible with your application.
Verify that settings are compatible with your application before
applying power to the drive.