Rockwell Automation 20G PowerFlex 750-Series AC Drives - Manual (Page 13)

Rockwell Automation Publication 750-RM002B-EN-P - September 2013 13
Preface
Product Safety
Class 1 LED Product
ATTENTION: An incorrectly applied or installed drive can result in component
damage or a reduction in product life. Wiring or application errors such as under
sizing the motor, incorrect or inadequate AC supply, or excessive surrounding air
temperatures may result in malfunction of the system.
This drive contains ESD (Electrostatic Discharge) sensitive parts and assemblies.
Static control precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD control procedures
are not followed. If you are not familiar with static control procedures, reference
Guarding Against Electrostatic Damage, publication 8000-4.5.2, or any other
applicable ESD protection handbook.
Configuring an analog input for 0-20 mA operation and driving it from a voltage
source could cause component damage. Verify proper configuration prior to
applying input signals.
A contactor or other device that routinely disconnects and reapplies the AC line to
the drive to start and stop the motor can cause drive hardware damage. The drive is
designed to use control input signals to start and stop the motor. If an input device
is used, operation must not exceed one cycle per minute or drive damage will
occur.
Drive must not be installed in an area where the ambient atmosphere contains
volatile or corrosive gas, vapors or dust. If the drive is not going to be installed for a
period of time, it must be stored in an area where it will not be exposed to a
corrosive atmosphere.
ATTENTION: Hazard of permanent eye damage exists when using optical
transmission equipment. This product emits intense light and invisible
radiation. Do not look into module ports or fiber optic cable connectors.