Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers - Manual (Page 108)

Publication 1753-PM001A-EN-P - November 2005
B-2 Configure the GuardPLC OPC Server
Choose an IP Address Choose an IP address for the OPC Server and the GuardPLC controller.
In this example, we used the default IP address of the GuardPLC
controller, 192.168.0.99. The IP address of the OPC Server is
192.168.0.216.
Add the GuardPLC
Controller and the OPC
Server to the Project 1. In RSLogix Guard PLUS! software, choose Project>New.
2. Enter the name of the project and confirm OK. In this example,
our project is called ‘OPCtest’.
3. In the Hardware Management window, expand Configuration so
that the Resource is visible.
In this example, we renamed the resource to G16OPC01. It is
not necessary to rename the resource.
4. Right-click G16OPC01 and choose Properties.
5. Change the SRS to 60000 and the Type to the controller you are
using. This example uses a GuardPLC 1600 controller.
6. Press Apply and check the remaining check boxes.
7. Click OK.