Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers - Manual (Page 43)

Publication 1753-PM001A-EN-P - November 2005
Create a GuardPLC Project 3-3
3. Edit the properties as shown below.
The Resource Type needs to match the type of GuardPLC
controller to which you want to connect. The SRS is a code that
is compiled with the function block routine. The routine can be
downloaded only to a GuardPLC controller with a matching SRS
code stored in its non-volatile memory. For more information on
configuring the controller, refer to the controller configuration
chapter of the GuardPLC Controller Systems User Manual,
publication number 1753-UM001.
4. Click Apply to move these values into the project.
5. Check the four (4) unchecked boxes and click OK.
TIP
The default SRS of a new controller is 60000.
You must use this SRS to initially establish
communications with the controller. Once you
have established communications, you can
change the SRS.
TIP
You can rename the controller using the
Program Management window. Expand the
project tree and the Configuration.
Right-click on Resource and choose
Rename.