Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers - Manual (Page 79)

1 Publication 1753-PM001A-EN-P - November 2005
Chapter
6
Access Management
In This Chapter
How the Controller Uses
Access Levels An Administrator can set up access privileges for a maximum of ten
users per controller. The controller stores the access privileges in its
non-volatile memory. The access privileges are not saved with the
program, and are not downloaded to the controller with the program.
If the controller is changed, access privileges must be re-entered.
Every controller has the same default user account, which applies
when:
• the controller is new, out of the box.
• disconnecting the operating voltage with the backup battery
removed (GuardPLC 1200/2000 controllers only).
• using the Reset button (GuardPLC 1600/1800 controllers only).
Refer to the GuardPLC Controller Systems User Manual,
publication number 1753-UM001, for details on how to use the
Reset button.
The default account is:
Username: Administrator
Password: <blank>
Access Type: Administrator
For information about See page
how the controller uses access levels 6-1
creating user access 6-2