Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers - Manual (Page 51)

Publication 1753-PM001A-EN-P - November 2005
Create a GuardPLC Project 3-11
3. Connect these signals to the analog inputs on the Inputs tab of
the Signal Connections dialog.
4. Choose the Outputs tab of the Signal Connections dialog.
5. Connect the USED signal from the Signal Editor to the analog
input channels you are using for your application.
Connect High-speed Counter Signals (GuardPLC 1800 Controllers)
To connect signals to the high-speed counters on the GuardPLC 1800
controller, you must first create signals to configure the high-speed
counters. You will also need to create signals for the counter values.
Then, connect these signals to the counter inputs and outputs.
Create Configuration and Counter Value Signals
1. In the Signal Editor, create true and false signals with constant
values. True signals have a value of 1; false signals have a value
of 0.