Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers - Manual (Page 114)

Publication 1753-PM001A-EN-P - November 2005
B-8 Configure the GuardPLC OPC Server
Generate Code for the OPC
Server 1. To generate the XML file for the OPC server, right-click the OPC
Server and choose Code Generator.
The process should take only 1 or 2 seconds. Make sure there
are no warnings or errors.
2. The resulting XML file is located in the project path of the
RSLogix Guard PLUS! project. Make note of this path so that you
can point to it from the GuardPLC OPC Server.
3. Return to the Project Management window and save the project.
4. Right-click Configuration and choose Code Generation. Check
the Error State Viewer to make sure there are no errors or
warnings. Correct any errors indicated.
Go Online with the
Controller 1. Return to the Hardware Management window and download the
project to your controller.
2. Put the controller into RUN.
3. Minimize RSLogix Guard PLUS! software.
Use the OPC Server 1. Start the GuardPLC OPC Server by choosing
Start>Programs>RSLogix Guard PLUS>GuardPLC OPC Server.