Create signals, Create signals -4 – Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers User Manual
Page 44
Publication 1753-PM001A-EN-P - November 2005
3-4 Create a GuardPLC Project
6. Expand the Resource so that the Hardware Management project
tree appears as shown below.
7. Right click COM under the GuardPLC 1800 controller, and
choose Properties.
8. Enter the IP address of your GuardPLC controller. Neither the
Subnet Mask nor the Default Gateway should require changes.
9. Click OK.
Create Signals
Because the example in this chapter uses the GuardPLC 1800
controller, there are predefined I/O listed under the controller in the
project tree. The 1200/1600/1800 are fixed controllers with
pre-configured I/O. If you use a GuardPLC 2000 controller, the I/O
must be configured, since it is a modular controller.
TIP
T
The GuardPLC controller’s default IP address is
192.168.0.99.