Step 10: ping the controller -15, Step 10: ping the controller – Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers User Manual
Page 25
Publication 1753-PM001A-EN-P - November 2005
Connect to the GuardPLC Controller 1-15
To reset the controller:
1. Hold down the Reset button, then power cycle the GuardPLC
controller.
2. Continue to hold down the Reset button until the PROG led
stops flashing.
At the next power cycle, the settings will revert back to the last
configured settings. These could be the settings in place prior to the
Reset operation, if you did not reconfigure them after resetting the
controller.
Step 10: Ping the Controller
Use the Start menu to open the RSLogix Guard PLUS! Command
Prompt.
1. Choose Start>Programs>RSLogix Guard PLUS>RSLogix Guard
PLUS Command Prompt.
2. Run IPCONFIG at the DOS Command prompt to verify your
computer’s IP address. It must be on the same local network as
the GuardPLC controller.