Rockwell Automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardPLC Controllers - Manual (Page 26)

Publication 1753-PM001A-EN-P - November 2005
1-16 Connect to the GuardPLC Controller
3. Ping the GuardPLC controller using the command shown at the
C:\> below. If the ping is successful, the IP address of the
GuardPLC controller has been verified and the Ethernet link is
operating. If the ping was not successful either the IP address,
subnet mask, or Ethernet link is not correct. The picture below is
the result of a successful ping.
4. Type EXIT at the command prompt to close the Command
Prompt window.
Step 11: Configure the GuardPLC Controller’s IP Address
1. Expand the project tree in the Hardware Management window
until the controller COM icon is visible.
2. Right-click COM and choose Properties.