Rockwell Automation 1753-DNSI DeviceNet Safety Scanner for GuardPLC Controllers - Manual (Page 29)

1 Publication 1753-UM002A-EN-P - July 2005
Chapter
3
Set Up Your DeviceNet Network
To set up devices on the DeviceNet network, follow the procedures
listed below in order:
Connect a Computer to the
DeviceNet Network To access a network, either:
• connect directly to the network, or
• connect to a different network and browse to the desired
network via a linking device
Once you choose a network:
• Install the communication card, if required.
• Determine any network parameters for the computer, such as a
network address.
• Connect the computer to the network using the correct cable.
Configure a Driver for the Network
1. Start RSLinx
®
software.
2. Click on the Configure Driver button.
Procedure page
1. Connect a Computer to the DeviceNet Network 3-2
2. Commission All Nodes 3-2
3. Browse the Network 3-3
4. Safety Reset (Optional) 3-4
5. Set Passwords (Optional) 3-5
TIP
RSLinx provides online help for configuring
drivers and using linking (bridge) devices.