Rockwell Automation 1753-DNSI DeviceNet Safety Scanner for GuardPLC Controllers - Manual (Page 43)

1 Publication 1753-UM002A-EN-P - July 2005
Chapter
5
Configure DeviceNet Nodes and Connections
To configure standard, safety, and peer-to-peer connections, follow
the procedures listed below in order:
Configuration Signature Each safety device has a unique Configuration Signature, which
identifies its configuration to ensure the integrity of configuration data
during downloads, connection establishment, and module
replacement.
The Configuration Signature is composed of an ID number, a Date
and a Time and is set automatically by RSNetWorx for DeviceNet
when a configuration update is applied to the device. The
Configuration Signature is found on the Safety tab of the Device
Properties dialog.
Procedure page
1. Configure DeviceNet Safety I/O Target Nodes 5-2
2. Configure the DeviceNet Safety Scanner’s Safety Connections 5-3
3. Configure DeviceNet Standard Slave I/O Nodes 5-6
4. Configure the DeviceNet Safety Scanner’s Standard Connections 5-6
5. Configure GuardPLC Controller Settings 5-12