Rockwell Automation 1753-DNSI DeviceNet Safety Scanner for GuardPLC Controllers - Manual (Page 90)

Publication 1753-UM002A-EN-P - July 2005
10-6 Monitor Status
000F Permission denied. See the extended error codes on pages 10-7 to 10-8.
0010 Device state conflict occurred.
0011 Reply will not fit.
0012 Fragmentation of a primitive value. For example, the service specified an
operation that is going to fragment a primitive data value, such as half a
REAL data type.
0013 Command data is insufficient.
0014 Attribute is not supported.
0015 Too much data present.
001A Bridge request is too large.
001B Bridge response is too large.
001D Attribute list is invalid.
001E Embedded service error occurred.
001F Connection related failure occurred. See the extended error codes on
pages 10-7 to 10-8.
0022 Invalid reply received.
0025 Key segment error occurred.
0026 Path size is invalid. Either the size of the path was not large enough, or too
much data was included.
0027 An unexpected attribute was encountered in the list.
0028 DeviceNet error, member ID is invalid.
0029 DeviceNet error, member is not settable.
00D1 The module is not in the run state.
00FB The message port is not supported.
00FC The message data type is unsupported.
00FD The message is uninitialized.
00FE The message has timed out.
00FF A general error occurred. See the extended error codes on pages 10-7 to
10-8.
General
Status
Error Code
(00gg) Description