Rockwell Automation 1753-DNSI DeviceNet Safety Scanner for GuardPLC Controllers - Manual (Page 32)

Publication 1753-UM002A-EN-P - July 2005
3-4 Set Up Your DeviceNet Network
Safety Reset (Optional) If you need to reset the safety device’s attributes to the out-of-box
default state, you can do so via the Reset Safety Device dialog.
You can reset the attributes shown on the Reset Safety Device dialog
by checking their associated checkbox. Leaving an attribute checkbox
blank preserves that attribute’s setting during the safety reset
operation.
1. Open the Reset Safety Device dialog by clicking on the device in
the RSNetWorx for DeviceNet graphic view and selecting Reset
Safety Device from the Device menu.
2. Check the attributes you want to reset.
Attribute Reset Behavior
Configuration The configuration checkbox is always checked to indicate that
the configuration of the device is erased as a result of any safety
reset action.
Configuration
Owner Check this checkbox to reset the device’s configuration owner.
The next device that attempts to configure the device following
the safety reset becomes the configuration owner.
Output
Connection
Owner(s) Check this checkbox to reset any existing output connection
owners. The next device that accesses an output connection
point following the safety reset becomes the output connection
owner.
Password Check this checkbox to reset the device password. You must
know the current device password to reset a password from the
Reset Safety Device dialog.
Address Check this checkbox to reset the device’s software-configured
node Address to 63.
NOTE: If the device’s node Address has been set using DIP
switches, the reset operation has no effect on the node Address.
Baud Rate Check this checkbox to reset the device’s baud rate to 125 kbps.
NOTE: If the device’s baud rate has been set using DIP switches,
the reset operation has no effect on the baud rate.
Safety Network
Number Check this checkbox to reset the device’s Safety Network
Number.