Rockwell Automation 1753-DNSI DeviceNet Safety Scanner for GuardPLC Controllers - Manual (Page 79)

Publication 1753-UM002A-EN-P - July 2005
Verify Your DeviceNet Safety Configuration 9-3
Select Devices to Verify Choose which devices to verify using the checkboxes in the Verify
column of the Verify Safety Device Configuration dialog. You can
select only the devices whose status is ‘Ready to be verified’.
If the Show all safety devices checkbox is checked, the dialog lists all
of the safety devices on the network and shows their current status. If
it is unchecked, which is the default, only devices with the following
status are shown:
• Verify FAILED
• Ready to be verified
• Verify not supported
These states are described in the following table.
Status Description
Verify FAILED The upload and compare operation indicated that the configuration
in the device does not match the configuration in the RSNetWorx
for DeviceNet configuration file.
Ready to be verified The device is not Safety-Locked and can be selected for
verification.
Verify not supported The device is not Safety-Locked, but the device does not support
verification via the Safety Device Verification Wizard. Consult your
user documentation for information on how to verify this device.
Once the device has been verified, it can be Safety-Locked by the
wizard.