Rockwell Automation 1753-DNSI DeviceNet Safety Scanner for GuardPLC Controllers - Manual (Page 57)

1 Publication 1753-UM002A-EN-P - July 2005
Chapter
6
Create a GuardPLC Project with High-Speed
Safety Protocol
To configure the GuardPLC controller to communicate with the
DeviceNet Safety Scanner for GuardPLC Controllers, follow the
procedures listed below in order:
For detailed information on creating a GuardPLC controller project in
RSLogix Guard PLUS!, refer to the GuardPLC Controller Systems User
Manual, publication number 1753-UM001.
Create or Open a GuardPLC
Project
1. In RSLogix Guard PLUS!, either open an existing GuardPLC 1600
or GuardPLC 1800 controller project or create a new project by
selecting Project>New from the main menu.
If the project is new, enter the name of the project in the Object
Name field and click OK. RSLogix Guard PLUS! automatically
creates a single resource in a new project.
Procedure page
1. Create or Open a GuardPLC Project 6-1
2. Add High-Speed Safety Protocol to the GuardPLC Controller Resource 6-3
3. Review the GuardPLC Controller’s Communication Settings 6-5
TIP
To optimize performance and minimize compilation
time, create and store your projects on a local drive.
TIP
You can rename the controller Resource in the
Project Management window by right-clicking
on the Resource and selecting Rename from
the context menu.