Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 101)

Publication 2707-PM002B-EN-P
Transferring / Printing Application Files 14-3
The MicroView Operating Menu appears.
7. Highlight Download File to MicroView and press [Return].
The Communication Port Selection screen appears. You will not
see this screen if a communication port was specified during
DPS installation.
8. Highlight the serial port on your computer that is connected to
the MicroView (COMM1 or COMM2) and press [Return].
The DPS software establishes a communications link with the
MicroView. If a communication link does not occur in 90
seconds you will get an error message. Check the Mode setting
and cable connections.
9. Select the application program you want to transfer and press
[Return].