Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 84)

Publication 2707-PM002B-EN-P
12-6 Entering MicroView Configuration Data
Setting Master Security
Code When you select Master Code from the Configuration - Option
Selection menu, the following is displayed:
Enter a new security code. There are two codes that perform special
functions:
•
00000000 disables the security function. This allows an
operator to enter any number as a valid access code.
•
99999999 disables the master security code(s). When used,
only the security code(s) assigned to individual screens are
valid. Use this code when you do not want to provide an
operator the ability to override or change security codes for
security screens.
The security code must be an 8 digit number, if you enter less than 8
digits, the remaining values are set to 0. The operator must enter all
eight numbers (including zeroes) for a valid code.
To save the new security code, press [Esc]. You are returned to the
Configuration - Option Selection menu.
ATTENTION
!
Keep a record of the Master Security Code. If you or
another user does not remember the Master Security
Code, the unit is disabled. You must return the unit
to the factory for repair.