Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 87)

Publication 2707-PM002B-EN-P
Entering MicroView Configuration Data 12-9
MicroLogix Hardware
Parameters When using DF1 protocols, you must specify the operating parameters
that allow the MicroView to communicate with the controller. The
MicroView settings must match the settings of the controller.
When you select PLC Hardware Parameters from the Configuration -
Option Selection menu, the following is displayed:
To save the new hardware parameters, press [F9]. To exit the screen,
press [Esc]. You are returned to the Configuration - Option Selection
menu.
Hardware
Parameter
Purpose
Com Port Setup Defines the baud rate used for communication with the
controller.
Advisor Update Rate Sets the rate at which the MicroView reads the advisor
register.