Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 53)

Publication 2707-PM002B-EN-P
Creating Data Display Screens 7-7
16 Bit Signed Integer, 16 Bit Unsigned Integer, 16 Bit BCD (Binary
Coded Decimal)
The screen for a 16 Bit Unsigned Integer format is shown below. The
screens for 16 Bit Signed Integer and 16 Bit BCD formats are similar.
Format Selection Description
Register Number The controller address from which the integer will be monitored.
Digits Right of Decimal The number of digits to be placed to the right of the decimal.
Digits Left of Decimal The number of digits to be placed to the left of the decimal.
Leave Place for Sign (Y or N) Provides for a one character place for the polarity sign (+ or –)
when the data is displayed, if desired.
Show Leading Zeros (Y or N) Provides for any zeros to the left of the data, if desired.
Minimum Register Value The minimum data value of the controller address being
monitored.
Maximum Register Value The maximum data value of the controller address being
monitored.
Minimum Displayed Value The minimum data value to be displayed. This value is displayed
when the data in the controller address is equal to the minimum
register value and scaling is enabled.
Maximum Displayed Value The maximum data value to be displayed. This value is displayed
when the data in the controller address is equal to the maximum
register value and scaling is enabled. The range defined by the
Minimum Displayed Value and the Maximum Displayed Value is
proportionally scaled to the range of the minimum and maximum
register values. If both ranges are equal then the scaling ratio is
1:1.