Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 103)

Publication 2707-PM002B-EN-P
Transferring / Printing Application Files 14-5
Uploading an Application This section shows how to upload an application from the MicroView
to a computer running DPS software.
1. Apply power to the MicroView and set the MicroView to the
Program Mode.
•
Press the[MODE] key
•
[3] for Special,
•
[3] for Program,
2. [1] for Upload (Download).
3. The following message will appear in the window of the
MicroView.
If you do not see this message, consult the MicroView Users
Manual (Publication No. 2711-UM005B-EN-P) for information on
how to access the Program Mode.
4. On your computer, move to the /MDPS subdirectory where the
software resides.
C:\MDPS>
5. Type dps and press [Return] to start the program.
C:\MDPS>dps [Return]
6. Specify whether you are using a color monitor. Enter [Y] or [N].
You will not see this prompt if a monitor was specified during
installation.
The startup screen displays.
7. Press any key to continue.
Programming Mode
“MENU” to Exit