Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 14)

Publication 2707-PM002B-EN-P
2-4 Installing and Running the MicroView Programming Software
5. Press any key (other than [Esc] ) to continue.
This screen appears.
6. Use the [ ][ ] arrow keys to highlight the drive on which you
want to install DPS and press [Return]. The default drive is C:
This screen appears:
TIP
You cannot install the DPS software on the
same drive the Install program resides.
Now you need to specify the disk destination subdirectory.
The subdirectory is the location on your disk where the
Bul. 2707 MicroView prog. S/W will be installed.
If you don’t know what a “subdirectory” is, you probably
need not worry about it, and should press [Enter] for the next
prompt (don’t type the quote characters).
Which subdirectory ([Enter] = \MDPS) ?
\MDPS