Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 52)

Publication 2707-PM002B-EN-P
7-6 Creating Data Display Screens
Display Register Format
Selections When inserting a data display field, you must provide register
information that determines the address and format of the data being
displayed. This section describes options available for data display
registers.
Bit
The register information for a Bit display is shown below.
See Appendix C
for default Bit text.
Format Selection Description
Register Number The controller address from which the bit will be
monitored.
Bit Number The Bit number of a multiple bit address which will be
monitored for status if the register number designates a
multiple bit address (a 16 bit data address, for example).
This selection is unavailable if the register number refers
to a Bit type address.
Text when Bit is OFF (0) The text description (16 character maximum) to be
displayed when the bit is in an OFF (0) state.
Text when Bit is ON (1) The text description (16 character maximum) to be
displayed when the bit is in an ON (1) state.