Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 34)

Publication 2707-PM002B-EN-P
4-4 Creating or Editing an Application File
Note: If the same file name currently exists, you are prompted
if you want to overwrite the existing file.
2. Press [Return] to save the application under the file name
entered when the application file was opened.
Or enter a new file name of less than eight characters:
If you were creating a new file, the new file name replaces the
file name entered when the application was opened.
If you are editing an existing file, the original file is unchanged.
The file and all edits made prior to the last save are stored under
the new file name.
3. After saving the file, you can continue editing the application
program.
To save an application before exiting:
1. Exit the software by pressing [F10].
You are prompted save the application under the current file
name or you can enter a new file name.
2. If you enter a new file name, the original file is unchanged and
all edits are stored under the new file name.
After saving the file, you are returned to the DOS prompt.
FILE EXISTS!!! OVERWRITE? (Y or N)