Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 104)

Publication 2707-PM002B-EN-P
14-6 Transferring / Printing Application Files
The MicroView Opening Menu Appears.
8. Highlight Upload File From MicroView and press [Return].
The Communication Port Selection screen appears. You will not
see this screen if a communication port was specified during
DPS installation.
9. Highlight the serial port on your computer that is connected to
the MicroView (COMM 1 or COMM 2) and press [Return].
The DPS software establishes a communications link with the
MicroView. If a communication link does not occur in 90
seconds you will get an error message. Check the Mode setting
and cable connections.