Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 13)

Publication 2707-PM002B-EN-P
Installing and Running the MicroView Programming Software 2-3
Installing MicroView
Programming Software This section shows how to install the software on a personal computer
with at least 1 hard disk drive and 1 floppy disk drive. The software is
supplied on one high density 3
1
/
2
inch disk
1. Turn on your computer. Your computer prompt will display the
currently active drive: A:, B:, or C:
2. Insert the DPS installation disk into the floppy drive.
3. Select the drive containing the disk (A: or B:) and press [Return].
Normally this is the A: drive.
C:> A: [Return]
A:>
4. Type install and press [Return] to start the installation.
A:> install [Return]
The following screen appears:
This program will install Bul. 2707 MicroView Prog. S/W V1.00
on your computer system and verify the integrity of the
distribution disk(s).
You may press the [Esc] key at any time to abort the installation.
Each question has a default answer. If the default answer is
correct, press the ENTER key in response to the question.
Otherwise, type the answer and then press the ENTER key.
Press [Esc] to quit, any other key to continue . . .