Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 42)

Publication 2711-PM002B-EN-P
5-8 Using Screen Builder
Exiting Screen Builder You can exit Screen Builder at any time during the design of an
application. Screen edits are not lost when you exit Screen Builder,
however, we recommend that you press [F9] SAVE before exiting.
To exit Screen Builder:
1. Press [Esc].
If you haven’t established screen linking, you are provided a
reminder:
2. Press [Y] to acknowledge the reminder (if displayed).
After exiting Screen Builder, the Edit File - Option Selection
menu is displayed.
You can re-enter Screen Builder later for additional edits or to
establish screen linking.
WARNING 01: Screen Number 002 has not been mapped.
WARNING 01: Screen Number 003 has not been mapped.
WARNING 01: Screen Number 007 has not been mapped.
WARNING 01: Screen Number 008 has not been mapped.
WARNING 01: Screen Number 011 has not been mapped.
PRESS ‘Y’