Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 120)

Chapter 14
Entering DTAM Configuration Data
14–14
SLC 500 Node Address
The SLC 500 Node Address defines the node address of the SLC 500 that the
DTAM will communicate with. The default address for the SLC 500 is
address 1.
DTAM Node Address
The DTAM Node Address defines the node address of the DTAM.
The default address for the DTAM is 0.
Note: We recommend the DTAM always be set to a node address less than
the SLC for best performance.
SLC Hardware Parameters