Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 136)

Chapter 16
DTAM Micro
Function Key Builder
16–4
You can link function keys [F1] through [F8] to individual screens (except
alarm screens). You can only link the function keys of the DTAM Micro,
this procedure does not apply to the DTAM Plus.
To link screens to function keys:
1. At the Opening menu select Edit Program File and enter a file name.
The Edit File - Option Selection menu is displayed.
2. Select Function Key Builder.
The Function Key Builder screen appears.
3. Use the arrow keys to highlight the function key you want to assign.
4. Enter a screen number for the function key and press [Return]. If you
want to see the screen you are assigning, press [F1] and [F2].
You are prompted if you want the key to auto return.
5. Enter [Y] for Auto Return Mode or [N] for Continue Mode and press
[Return].
6. Assign the remaining function keys. If you want to assign bit write mode
functions, refer to the next section.
7. Press [F9] to save the screen.
Linking Screens to
Function Keys