Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 123)

Chapter 14
Entering DTAM Configuration Data
14–17
Com Port Setup with PLC5 Operating System
Note: See next page for Remote I/O port setup on Remote I/O terminals.
Selecting Com Port Setup displays:
The Communications Port parameters have the following default values for a
PLC:
Baud Rate: 2400
Parity: None
Data Bits: 8
Baud Rate
Default is 2400 baud. Baud rate options are 38400, 19200, 9600, 4800,
2400, 1200, and 300. Select a baud rate that matches your PLC.
Parity
Default is no parity. Parity options are None, Odd, or Even.
Data Bits
Defines the word length, the default is eight bits. Data bit options are Seven
or Eight bits.