Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 150)

Chapter 19
Transferring / Printing Application Files
19–2
This section shows how to download an application from a computer running
DPS software to the DTAM.
1. Apply power to the DTAM.
The following message appears in the window of the DTAM.
Programming Mode
Waiting Up/Download
If you do not see this message, check the DIP switch settings.
DIP Switch 1 must be in the Closed (ON) position.
2. On your computer, move to the /DPS subdirectory where the software
resides.
C:\DPS>
3. Type dps and press [Return] to start the program.
C:\DPS>dps [Return]
4. Specify whether you are using a color monitor. Enter [Y] or [N].
5. The startup screen displays:
Voice: 440–646–6800
FAX: 440–646–6850 or 6890
E–mail: [email protected]
Downloading
an Application
. You will not see this prompt if
a monitor was specified during
installation.