Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 17)

Chapter 2
Installing / Running
DTAM Programming Software
2–5
7. Press [Return] to install the DPS software in the \DPS subdirectory. The
Install program creates the subdirectory. If you enter your own
subdirectory name, the entire path name including colons, forward slash,
and name should not exceed 28 characters.
The status of the installation is displayed on the screen.
The DPS Configuration Utility screen then appears:
8. Enter your name, company name, and software serial number (on
registration card). Also, enter the monitor type and communication port
used by your computer.
The software serial number is required when requesting phone support
(refer to startup screen on next page).
9. After responding to the above questions, you are asked to confirm the
configuration. Press [Return] to accept the configuration.
10. The installation is complete. You are returned to DOS at the new
subdirectory C: \DPS>.
☞ You can specify another
directory. The Install program
will create the directory if it
does not exist.
☞ Press [Return] at the Video
Type and Comm Port questions
to prompt the user for this
information during application
development.