Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 154)

Chapter 19
Transferring / Printing Application Files
19–6
This section shows how to upload an application from the DTAM to a
computer running DPS software.
1. Apply power to the DTAM.
The following message appears in the window of the DTAM.
Waiting For Program
Upload / Download
Programming Mode
Programming Mode
Waiting For Program
DTAM Plus DTAM Micro
If you do not see this message, check the DIP switch settings.
DIP Switch 1 must be in the Closed (ON) position.
2. On your computer, move to the /DPS subdirectory.
C:\DPS>
3. Type dps and press [Return] to start the program.
C:\DPS>dps [Return]
4. Specify whether you are using a color monitor. Enter [Y] or [N].
5. The startup screen displays.
Voice: 440–646–6800
FAX: 440–646–6850 or 6890
E–mail: [email protected] Technical Support
Uploading
an Application
. You will not see this prompt if
a monitor was specified during
installation.