Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 20)

Chapter 2
Installing / Running
DTAM Programming Software
2–8
You are now ready to create a file for your application.
The following chart lists the various protocols and the corresponding
controllers:
AB DH485
PLC5 DF1 SLC or Micro Logix (Series C or later)
PLC5 or Micro Logix
DTAM Plus
PLC5 DF1
RI0
DN PLC5 or Micro Logix
PLC5 or SLC w/1747-SN
PLC or SLC w/★-SDN
DTAM Micro
AB DH485
PLC5 DF1
DN SLC or Micro Logix (Series C or later)
PLC5 or Micro Logix
PLC or SLC w/★-SDN
MicroView
Micro Logix DF1
DN Micro Logix
PLC or SLC w/★-SDN
Note: Once a protocol has been selected and the file has been saved, you
can not change the protocol. A new file must be created when a different
protocol is selected.