Rockwell Automation 2707-NP DTAM Programming Software User Manual
Page 156
Advertising
Chapter 19
Transferring / Printing Application Files
19–8
9. Highlight the serial port on your computer that is connected to the
DTAM (COMM 1 or COMM 2) and press [Return].
10. The upload begins and the following screen shows the progress of the
upload operation.
After the upload is complete, you are prompted to enter a file name for
the application.
11. Enter the file name for the uploaded application, you are returned to the
Opening menu.
12. Press [Esc] to exit the software.
13. Press [Y] to return to DOS.
The application is now loaded into the DPS software and can be edited
like any other application file.
☞
If a communication link does not
occur in 10 seconds, you get an
error message. Check DIP switch
settings and cable connections.
Advertising