Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 122)

Chapter 14
Entering DTAM Configuration Data
14–16
When using PLC-5 DF1 or Remote I/O protocol, you must specify the
operating parameters that allow the DTAM Plus or DTAM Micro to
communicate with the controller. The DTAM settings must match the
settings of the PLC-5. If you are communicating with an SLC or DH-485
network, refer to the previous section SLC Hardware Parameters.
When you select PLC Hardware Parameters from the DPS Configuration -
Option Selection menu, the following is displayed:
PLC-5 DF1 files cannot be upgraded or downgraded like SLC file types.
Applies to:
Hardware
Parameter
DTAM
Plus
DTAM
Micro Purpose
Com Port Setup
✓ ✓
Defines the baud rate, parity, and number
of data bits used for communication with a
PLC-5.
Advisor Update Rate
✓ ✓
Sets the rate at which the DTAM reads the
advisor register.
PLC Hardware Parameters