Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 15)

Chapter 2
Installing / Running
DTAM Programming Software
2–3
This section shows how to install the software on a personal computer with
at least 1 hard disk drive and 1 floppy disk drive. The software is supplied
on 3
1 /
2
inch disks.
1. Turn on your computer. Your computer prompt will display the currently
active drive: A:, B:, or C:
2. Insert the DPS installation disk into the floppy drive.
3. Select the drive containing the disk (A: or B:) and press [Return].
Normally this is the A: drive.
C:> A: [Return]
A:>
4. Type install and press [Return] to start the installation.
A:> install [Return]
The following screen appears:
Installing DTAM
Programming Software