Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 78)

Chapter 8
Creating Data Entry Screens
8–10
32 Bit Unsigned Integer,
32 Bit BCD (Binary Coded Decimal)
The screen for a 32 Bit Unsigned Integer format is shown below. The screen
for a 32 Bit BCD format is similar.
SLC or PLC
depending upon protocol.
Format Selection Description
Register Number The controller data address to be monitored.
Digits Right of Decimal The number of digits to be placed to the right of the decimal.
Digits Left of Decimal The number of digits to be placed to the left of the decimal.
Low User Input Limit The minimum entry value that an operator may enter. This value
must be within the range of the data format selected. If a value lower
than this is entered, the DTAM will display an “Input Error” screen
displaying the minimum and maximum entry limits.
High User Input Limit The maximum entry value that an operator may enter. This value
must be within the range of the data format selected. If a value
higher than this is entered, the DTAM will display an “Input Error”
screen displaying the minimum and maximum entry limits.
Default Value This parameter defines a default value that is displayed at the entry
address of the display. An entry of Z defines no default.
NONE appears in the window when Z is entered.