Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 38)

Chapter 4
Creating or Editing an Application File
4–2
To create or edit an application:
1. Select Edit Program File to create or edit a DTAM application file.
You are prompted for the file name to edit or create. All DTAM
application files in the current directory are listed.
The directory only lists files compatible
with the currently specified hardware type.
For example, if DTAM Micro is specified
only DTAM Micro applications are listed.
If files already exist, each file name is followed by the type of Operating
System the file was created for:
•
AB DH485 for point to point or 32 node operation with SLC
controllers.
•
PLC5 DF1 for DF1 connection to PLC-5 serial port (channel 0).
•
AB BASIC only applies to DTAM Plus programming when
communicating with an SLC BASIC module (Catalog No.
1746-BAS).
•
RIO only applies to DTAM Plus programming when communicating
with an a PLC-5 or SLC 5/03 / 5/04 over a remote I/O link.
2. Select the name of an existing application file or enter a new file name.
If you entered a new file name, you must select an operating system:
Edit Application File