Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 65)

Chapter 7
Creating Data Display Screens
7–9
32 Bit Unsigned Integer,
32 Bit BCD (Binary Coded Decimal)
The screen for a 32 Bit BCD format is shown below. The screen for a 32 Bit
Unsigned Integer format is similar.
SLC or PLC
depending upon protocol.
SLC or PLC
depending upon protocol.
Format Selection Description
Register Number The controller address to be monitored.
Digits Right of Decimal The number of digits to be placed to the right of the decimal.
Digits Left of Decimal The number of digits to be placed to the left of the decimal.
Show Leading Zeros (Y or N) Provides for zeros to the left of the data, if desired.
Note: For the 32 Bit selections, scaling of data is not supported. The selected
register number and the next higher sequential register number identify the
addresses defining the 32 bit data value.
Display Register
Format Selections