Rockwell Automation 2707-NP DTAM Programming Software - Manual (Page 72)

Chapter 8
Creating Data Entry Screens
8–4
5. Press [F2] to insert a data entry register.
You are prompted to select a register type. The selection depends upon
the protocol that was selected. Refer to page 3–3 for a list of the
applicable register types for each.
6. Select a register type.
You are prompted for data specific to the selected register type:
16 Bit Signed Integer Shown
7. Enter the register data. Refer to the next section Data Entry Register
Format Selections.
Creating a Data
Entry Screen