Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 11)

Publication 2711-QS003D-EN-P - June 2009 11
Preface
What You Need This section lists the requirements for creating, downloading and
running the application on a Remote I/O, DH+, DH-485, ControlNet,
DeviceNet, EtherNet/IP, or DF1 network.
Download Cables
Your terminal has an RS-232 (DF1), RS-232 (DH485), or DH-485 port
through which applications are transferred.
RS-232 Programming Port - To download an application to an
RS-232 programming port on a PanelView terminal, you will need a
download cable. Use one of the these cables:
•
2706-NC13 (3 m/10 ft)
•
2711-NC13 (5 m/16.4 ft)
•
2711-NC14 (10 m/32.7 ft)
For the PanelView 300 Micro terminal, use one these cables:
•
2711-CBL-PM05 (5 m/15 ft)
•
2711-CBL-PM10 (10 m/30 ft)
•
1761-CBL-AP00 (.5 m/1.5 ft)
•
1761-CBL-PM02 (2 m/6.5 ft)
DH-485 Programming Port - To download an application to a
DH-485 terminal you will need:
•
1747-PIC Personal Computer Interface Converter and a
1747-C10, -C11, or -C20 cable.
or
•
1761-NET-AIC link coupler and one these cables: 1747-CP3,
1761-CBL-AS03 (3 m/9.8 ft), or 1761-CBL-AS09 (9.9 m/27.5 ft).
The Personal Computer Interface Converter receives power from an
SLC controller. If you are downloading to a terminal without an SLC
connected, you will need either a power supply, catalog number
1747-NP1, or a powered link coupler, catalog number 1747-NET-AIC.