Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 58)

58 Publication 2711-QS003D-EN-P - June 2009
Chapter 4 Configuring Communication
Configure Remote I/O
Communication This section defines the communication settings for a Remote I/O
PanelView terminal and logic controller on a Remote I/O network.
1. Select Application>Settings.
2. On the Terminal Setup tab, click the Comms. Setup button.
Set the properties as shown.
3. Click OK until you exit the Application Settings dialog.
Important: LC_1 is
entered to match the
Node name in the Tag
Editor.
Select a controller:
- Select SLC 5/04 with 1747-SN/B scanner
- Select ControlLogix for ControlLogix with
DHRIO module
Check the firmware number to make sure
it matches your hardware.