Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 59)

Publication 2711-QS003D-EN-P - June 2009 59
Configuring Communication Chapter 4
Configure DeviceNet
Communication This section defines the communication settings for a DeviceNet
PanelView terminal operating as a slave device on a DeviceNet
network.
1. Select Application>Settings.
2. On the Terminal Setup tab, click the Comms. Setup button.
Set the properties as shown.
3. Click OK until you exit the Application Settings dialog.
Verify that the catalog number and firmware
number matches your hardware.
Type 2. Type 3.