Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 19)

Publication 2711-QS003D-EN-P - June 2009 19
System Setup Chapter 1
Remote I/O Connections Remote I/O versions of the PanelView terminal have both an RIO
adapter and an RS-232 file transfer/printer port. The RIO adapter lets
the terminal connect to any 1771 Remote I/O link. The PanelView
terminal connects to an RIO scanner using cable, catalog number
1770-CD, equivalent to Belden 9463.
Cable
2711-NC13, 2711-NC14, 2706-NC13
Node 2
PanelView 1000 RS-232
Terminal Shown
Node 0
Personal Computer
PanelBuilder32 Software
Node 1
PLC-5 Controller
RIO Port
1770-CD Cable
(Belden 9463)
RS-232 Port
Remote I/O Port
3-pin Terminal Block Connector
To RIO Port
Node 1
SLC Controller with
1747-SN Scanner Module
RIO Port
ControlLogix Controller
RIO Module (1756-DHRIO)
Important: Wire with clear insulation connects to
terminal #2 of the 3-pin Remote I/O connector.
82 or 150 Ohm
termination resistor
2 Clear
SH Shield
1 Blue
Clear 2
Shield SH
Blue 1
RIO Port
Serial Port
COM1 or COM2