Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual - Manual (Page 43)

Publication 2711-QS003D-EN-P - June 2009 43
Creating the Application Chapter 3
6. Double-click in the Message Text field of row 0 and 1 and
change the text as shown.
7. Click the Properties tab and set the properties as shown.
8. Click OK to exit the dialog.
Motor Stopped
State 0
Motor Running
State 1
Error State- If an error state occurs no state is highlighted.
Type Motor_Status_Ind
Select Single Bit
TIP
Because Single Bit only supports 2 states (State 0 and
State 1), you must delete the extra states on the States
tab before selecting Single Bit on the Properties tab.